LOW COST AND UNIQUE DESIGN

Short and Long Ultra HIgh Definition Raised Panels

Mission Series: Quality constructed 25 gauge, 2-inch thick uninsulated steel sectional garage door for the economically minded customer. Simply stated, no other door manufacturer builds a higher quality low cost steel door with the features of 1st United Door Technologies.

Specification: Sections are 2 inches thick, and manufatured from 25 gauge hot-dipped galvanized steel in 21 and 18 inch heights. Sections are pre-painted white and rotary embossed with a woodgrain texture. Ultra high definition raised panel are pressed in 1/8" height increments to a depth of .375. Tongue and groove-meeting rails are roll formed into the panel, incorporating the RITS ™ reinforced integral truss system. Vertical stile members are 19 gauge hot-dipped galvanized I-beams pre-painted white to match the interior side of the door. Stiles are riveted and bonded to the interior face of the door with an epoxy-based cement. Bottom secetions are reinforced with aluminum "L" angle and bonded to the section for supporting a replaceable UV protected bottom weather seal.

	Optional Energy Efficient Insulation. CFC free Polystyrene insulation with a rigid vinyl back skin, R factor of 6.25. Laminated PVC backing is available as a factory installed option.
	Exclusive RITS™ "Reinforced Integral Truss System" design, for increased section strength and wind-load capabilities that include tongue and groove weather resistant meeting rails.
	Reinforced Aluminum Bottom Extrusion. Heavy duty grooved "U" type weather seal is set into an aluminum reinforced "L" angle, and bonded to the bottom section.
	I-Beam Center Stiles. Pre-painted I-beam center stiles are engineered to reinforce the construction of the section and designed to eliminate the use of plastic reinforcement angles when the section is post insulated.
	Ten Coat Rust Protection.
	M25SP: Shown with optional Cascade door lites